Kia Cadenza YG: Fuel Delivery System / Fuel Shut Off Valve Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Shut Off Valve Repair procedures

Removal
1.
Lift the vehicle and support the fuel tank with a jack.
2.
Remove the nuts from fuel tank.
3.
Release the fuel tank bands (A).

4.
Disconnect the fuel filler hose (A).

5.
Remove the fuel shut off valve (A).

Installation
1.
Install in the reverse order of removal.
Inspection
1.
Visually check if the valve is are deformed or damaged.
2.
Check if the valve spring is oprerated normally.

    Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location

    Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0306