Kia Cadenza YG: Automatic Transaxle Control System / Line Pressure Control Solenoid Vale Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Vale Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).

4.
Measure the resistance between power terminal (5) and signal terminal (17).
Specification : 5.1 ± 0.3 Ω

Replacement
   
If a solenoid valve of VFS type needs to be replaced, the valve body assembly should be replaced and the oil pressure should be adjusted. If the solenoid valve is replaced individually, it is not possible to adjust the oil pressure without additional equipment, and if the oil pressure adjustment procedure is not performed, a shift shock or delay may occur.
1.
Replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")

    Circuit Diagram

    Specification ItemSpecificationControl type ON/OFFCurrent value (mA)5.0 Coil resistance(Ω)10 ~ 11 

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation

    Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Motor Repair procedures

    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0277