Kia Cadenza YG: Starting System / Starter Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Engine Electrical System / Starting System / Starter Description and Operation

Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor''s solenoid coil.
The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.The contacts close and the starter motor cranks.
In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

    Troubleshooting     • The battery must be in good condition and fully charged for this troubleshooting.

    Specification Starter ItemSpecificationRated voltage12 V, 1.7 kWThe number of pinion teeth12Performance[No-load, 11.5 V]AmpereMax.85 ASpeedMin. 2,550 rpm

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures

    Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.

    Kia Cadenza YG 2016-2021 Service Manual: Condenser Repair procedures

    Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0205