Kia Cadenza: Smart Cruise Control button and switch / To increase Smart Cruise Control set speed

Kia Cadenza YG 2016-2025 Owners Manual / Driving your vehicle / Smart Cruise Control (SCC) / Smart Cruise Control button and switch / To increase Smart Cruise Control set speed

Follow either of these procedures:

Move the RES+ switch up, and hold it. Your vehicle set speed will increase by 5 mph (10 km/h). Release the switch at the speed you want.
Move the RES+ switch up, and release it immediately.The cruising speed will increase by 1.0 mph (1.0 km/h) each time you move the RES+ switch up in this manner.
Although SCC will operate to a maximum setting of up to 120 mph (200 km/h), all local speed limit laws must always be followed.

WARNING

Check driving conditions before using the switch as driving speed increases rapidly when you push up and hold the switch.

Smart Cruise Control speed To set Smart Cruise Control Speed

1. Press the CRUISE button, to turn the system on. The Cruise indicator ( CRUISE) in the instrument cluster will illuminate. 2. Accelerate to the desired speed. Smart Cruise Control speed c ...

To decrease Smart Cruise Control set speed

Follow either of these procedures: Move the SET- switch down and hold it. Your vehicle set speed will decrease by 5 mph (10 km/h). Release the switch at the speed you want. Move th ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A). 4. Measure the resistance between power terminal (10) and signal terminal (2). Specification : 5.1 ± ...

Kia Cadenza YG 2016-2025 Service Manual: Battery Repair procedures

Removal 1. Remove the air duct (A). 2. Disconnect the battery (-) terminal (A)and then (+) terminal (B). 3. Remove the battery mounting bracket (D) and the insulation pad (C), and then remove the battery (E). 4. Disconnect the front connector mounting clip (A). 5. Remove the batt ...