Kia Cadenza YG: Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Specifications
| Specification |
| Item | Specification |
| Control type | N/L (Normal Low) |
| Control pressure kpa(kgf/cm², psi) | "9.81 ~ 500.14(0.1 ~ 5.1, 1.42 ~ 72.54)" |
| Current value (mA) | 50 ~ 850 |
| Coil resistance(Ω) | 5.1 ± 0.3 |
Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A).
Component Location 1. 26 Brake control solenoid valve (26/B_VFS)
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Inspection Tolerance Calibration Tolerance calibration compensates for the error margins of surround view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance calibration if you do any of the following.
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Diagnosis With GDS 1. BSD system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. 2. Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Timing Chain Repair procedures
- Engine Electrical System
- New on site
- Most important about car
