Kia Cadenza: Maintenance / Climate control air filter

Kia Cadenza YG 2016-2023 Owners Manual / Maintenance / Climate control air filter

Filter inspection

The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you replace the climate control air filter, replace it performing the following procedure, and be careful to avoid damaging other components.

1. Open the glove box and remove the stoppers on both sides.

2. With the glove box open, pull the support strap (1).

3. Remove the climate control air filter cover while pressing the lock on the right side of the cover.

4. Replace the climate control air filter.

5. Reassemble in the reverse order of disassembly.

When replacing the climate control air filter install it properly. Otherwise, the system may produce noise and the effectiveness of the filter may be reduced.

Air cleaner
Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. ...

Wiper blades
Blade inspection Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the wiper blades ...

Other information:

Kia Cadenza YG 2016-2023 Owners Manual: If the engine will not start


If engine doesn't turn over or turns over slowly 1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and tight. 3. Turn on the interior light. If the light dims or goes out when you operate ...

Kia Cadenza YG 2016-2023 Service Manual: Fuel Pressure Regulator Repair procedures


Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the electric pump wiring connector (A) and the fuel sender connector (B). 3. Remove the cushion pipe fixing clip (A), and then separate the head assembly (B) from reservoir cup. 4. Remo ...

Copyright © www.kcadenzavg.com 2017-2023