Kia Cadenza: Back View Camera System / Description and Operation
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the
vehicle through the ECM (Reverse Display Room Mirror) mirror or AVN head
unit while backing-up.
This system is a supplementary function only. It is the
responsibility of the driver or always check the inside/ outside
rearview mirror and the area behind the vehicle before and while backing
up because there is a dead zone that can''t see through the camera. |
Removal
1.
Remove the trunk trim in the trunk after removing the screws and clips.
(Refer to Body - "Trunk")
2.
Remove the camera holder (A) as shown arrow direction, and then remove the back ...
Other information:
Removal
1.
Loosen the windshield wiper arm nut (B) after removing a wiper cap (A).
2.
Remove the windshield wiper arm and blade (A).
3.
If necessary, release the wiper blade fixing clip by pulling up and remove the wiper blade from the inside radius of wiper arm.
4.
Disconnect the wa ...
Specifications
ItemSpecificationsTransaxle typeA6LF2Engine modelGasoline 3.3 GDITorque converter type3-element, 1-stage, 2-phase typeTorque converter sizeΦ260mm(10.2362 in)Oil pump systemParachoidFriction elementsClutch: 2EABrake: 3EAOWC : 1EAPlanetary gear 3EAGear ration1st4. ...