Kia Cadenza YG: Back View Camera System / Repair procedures
| Removal |
| 1. |
Remove the trunk trim in the trunk after removing the screws and clips.
(Refer to Body - "Trunk") |
| 2. |
Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B).
|
| Installation |
| 1. |
Install the back view camera and camera holder. |
| 2. |
Install the trunk tirm. |
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Temperature Control Actuator Repair procedures
Inspection 1. Ignition "OFF" 2. Disconnect the connector of temperature control actuator. 3. Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 7. Verify that the temperature control actuator operates to the cool position when connecting in the rev
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Restraint
- Engine Mechanical System
- Alternator Schematic Diagrams
- New on site
- Most important about car
