Kia Cadenza YG: Body Electrical System / Blind Spot Detection System
- Specifications
- Components and Components Location
- Description and Operation
- Repair procedures
- Blind Spot Detection Unit Schematic Diagrams
- Blind Spot Detection Unit Repair procedures
- Blind Spot Detection Variant Coding Description and Operation
- Blind Spot Detection Radar Calibration Description and Operation
- Blind Spot Detection Switch Components and Components Location
- Blind Spot Detection Switch Repair procedures
- Troubleshooting
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B).
Specifications ItemsSpecificationRated voltageDC 12VOperating voltage9V ~ 16VOperating speed15km/h ~ 250km/hSensible distance70m (Sedan)Curvature radiusStart : More than 100mStop : Less than 70mFrequency24 GHzNumbers2EA (Master 1EA, Slave 1EA)
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Lane Departure Warning System (LDWS) Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Remove the LDWS unit connector (A). 4. Remove the LDWS unit after widening the mounting clips. Installation 1. Install the LDWS unit. 2.
Kia Cadenza YG 2016-2021 Service Manual: Cluster ionizer Repair procedures
Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal50Cluster ionizer fault * Diagnostic procedure refer to DTC code. Replacement 1. Disconnect the negative (-) battery terminal.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Driveshaft and axle
- Schematic Diagrams
- Rail Pressure Sensor (RPS) Schematic Diagrams
- New on site
- Most important about car
