Kia Cadenza YG: Charging System / Battery Troubleshooting
| Troubleshooting |
Removal 1. Remove the air duct (A). 2. Disconnect the battery (-) terminal (A)and then (+) terminal (B). 3. Remove the battery mounting bracket (D) and the insulation pad (C), and then remove the battery (E).
Description Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Description and Operation
Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provided information , it calculates algorithm and adjust Low beam of H/Lamp. It transmits driving information by using LIN protocol, it is operated in Fail-safe reaction mode
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Mechanical System
- Restraint
- Transaxle Control Module (TCM) Repair procedures
- New on site
- Most important about car
