Kia Cadenza YG: Body (Interior and Exterior)
- Specifications
- Special Service Tools
- Troubleshooting
- Body Dimensions
- General Information
- Front Body Body Repair
- Side Body Body Repair
- Interior Body Repair
- Rear Body Body Repair
- Under Body Body Repair
- Exterior
- Fender Repair procedures
- Hood Repair procedures
- Trunk Lid Repair procedures
- Front Door Components and Components Location
- Front Door Repair procedures
- Rear Door Components and Components Location
- Rear Door Repair procedures
- Body Side Moulding Repair procedures
- Panoramaroof Components and Components Location
- Panoramaroof Repair procedures
- Mirror Repair procedures
- Cowl Top Cover Repair procedures
- Interior
- Console Components and Components Location
- Console Repair procedures
- Crash Pad Components and Components Location
- Crash Pad Repair procedures
- Roof Trim Components and Components Location
- Roof Trim Repair procedures
- Interior Trim Components and Components Location
- Interior Trim Repair procedures
- Trunk Trim Repair procedures
- Windshield Glass Components and Components Location
- Windshield Glass Repair procedures
- Rear Window Glass Repair procedures
- Bumper
- Front Bumper Components and Components Location
- Front Bumper Repair procedures
- Rear Bumper Components and Components Location
- Rear Bumper Repair procedures
- Seat & Power Seat
- Front Seat Components and Components Location
- Front Seat Repair procedures
- Rear Seat Components and Components Location
- Rear Seat Repair procedures
- Seat Belt
Description Steering Wheel Angle Sensor detects rotating direction of the vehicle. Rotating direction detected by the sensor is communicated with HECU as CAN signal involving information about the angle through CAN communication line.
Specifications ItemsSpecificationHoodTypeRear hinged, gas lifter typeFront DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemRear DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemTrunk LidTypeTorsior bar typeSeat BeltsFront3 point type with Emergency Locking Retractor (E.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.
Kia Cadenza YG 2016-2021 Service Manual: Auto defoging actuator Repair procedures
Inspection 1. Ignition "OFF”. 2. Disconnect the connector of auto defog control actuator. 3. Verify that the auto defog control actuator operates to the defrost ON mode when connecting 12V to the terminal 3 and grounding terminal 7. 4.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Battery Troubleshooting
- Alternator Schematic Diagrams
- Driveshaft and axle
- New on site
- Most important about car
