Kia Cadenza YG: Bumper / Rear Bumper Components and Components Location

Kia Cadenza YG 2016-2021 Service Manual / Body (Interior and Exterior) / Bumper / Rear Bumper Components and Components Location

Components(1)

1. Rear bumper cover
2. Rear bumper side bracket [RH]
3. Rear bumper side bracket [LH]
4. Tail trim cover

Components(2)

1. Rear bumper beam assembly
2. Rear bumper energy absorber
3. Rear bumper side bracket [RH]
4. Rear bumper side bracket [LH]
5. Rear bumper cover
6. Rear bumper deflector [RH]
7. Rear bumper deflector [LH]

8. Rear bumper side moulding [RH]
9. Rear bumper side moulding [LH]
10. Rear bumper center moulding
11. Tail trim assembly [RH]
12. Tail trim assembly [LH]
13. Rear bumper lower cover

    Replacement     • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

    Replacement     • After remove the rear combination lamp. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts your hands.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location

    C

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.     Make sure that there is no air leaking out of the blower and duct joints.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.027