Kia Cadenza YG: Bumper / Rear Bumper Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body (Interior and Exterior) / Bumper / Rear Bumper Repair procedures

Replacement
   
•
After remove the rear combination lamp.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts your hands.
•
Put on gloves to protect your hands.
•
Take care not bend or scratch the cover and other parts.
1.
Remove the trunk trim.
(Refer to the BD group - "Trunk Trim")
2.
Disconnect the rear bumper main connectors (A).

3.
Loosen the trunk inner mounting bolts.

4.
Disconnect the connector (B), and then loosen the rear combination lamp mounting nuts.
5.
Remove the rear combination lamp (A).

6.
Loosen the rear bumper upper side mounting screw and clips.

7.
Loosen the rear bumper lower side mounting clips.

8.
Loosen the mounting bolts.

9.
After loosening the rear bumper side''s mounting screws, then disconnect the side''s.
   
•
Remove the rear bumper by pulling up the side of the rear bumper and then pull it out.
   
•
When you pull out the rear bumper, the side part of the rear bumper could be damaged by the projection.

10.
Remove the rear bumper cover (A).

11.
Installation is the reverse of removal.
   
•
Make sure the connectorare connected in properly.
•
Replace any damage clips.

    Components(1) 1. Rear bumper cover2. Rear bumper side bracket [RH]3. Rear bumper side bracket [LH]4. Tail trim cover Components(2) 1. Rear bumper beam assembly2.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Adaptive Front Lighting System Description and Operation

    Description AFLS Unit(ECU) AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle). Based on provided information , it calculates algorithm and adjust Low beam of H/Lamp. It transmits driving information by using LIN protocol, it is operated in Fail-safe reaction mode

    Kia Cadenza YG 2016-2021 Service Manual: Surround View Monitoring Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") 3. Remove the SVM unit (B) after disconnecting the connectors (A) and mounting bolts. Installation 1. Install the SVM unit.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0293