Kia Cadenza YG: Air Conditioning System / Refrigerant line Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Refrigerant line Repair procedures

Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
   
Cap the open fittings immediately to keep moisture or dirt out of the system.
3.
Tighten joint of bolt or nut to specified torque.
   
Connections should not be torque tighter than the specified torque.
Part tightened
N.m
Kgf.m
lbf-ft
Condenser - Discharge hose
7.8~11.7
0.8 ~ 1.2
5.7~8.6
Condenser - Liquid tube
Compressor - Discharge hose
7.8~11.7
0.8 ~ 1.2
5.7~8.6
Compressor - Suction hose
Expansion valve - Evaporator
7.8~11.7
0.8 ~ 1.2
5.7~8.6

4.
Evacuate air in refrigeration system and charge system with refrigerant.
Specified amount : 19.4 ± 0.88 oz.(550 ± 25g)
5.
Inspect for leakage of refrigerant.
Using a gas leak detector, check for leakage of refrigerant.
6.
Inspect A/C operation.

    Component Location

    Components 1. Screw2. Blot3. Limiter Assembly4. Retainer Ring5. Pulley6. Compressor Assembly

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures

    Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.

    Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures

    Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.

    Categories

     
    Copyright © 2025 www.kcadenzavg.com - 0.0198