| Troubleshooting |
| Symptom | Suspect Area | Remedy (Refer to page) |
| Water leaks from panoramaroof | Deteriorated roof lid weatherstrip | Replace |
| Excessive roof lid-to-body clearance and improperly fitted weatherstrip | Adjust | |
| Wind noise around panoramaroof | Loose or deformed deflector, gaps in body work | Retighten adjust or replace |
| Noise heard when opening. closing panoramaroof | Foreign particles lodged in guide rail | Check drive cable and guide rails for foreign particles |
| Loose guide rails and lid | Retighten | |
| Motor runs but panoramaroof does not move or moves only partially | Foreign particles lodged in guide rail | Adjust or replace |
| Incorrect engagement of motor pinion with drive cable | ||
| Decrease in motor`s clutch slipping force | ||
| Increased
panoramaroof sliding resistanceor interference of sunroof with drive
cables, weatherstrip, etc. due tomal adjustment of sunroof | ||
| Noise in motor (clutch slipping noise from motor when sunroofIs fully opened or closed is not an unusual noise | Incorrect engagement of motor pinion with drive cable | Check pinion installation and retighten motor |
| Worn out or damaged motor pinion bearing | Replace motor assembly | |
| Worn out or deformed drive cable | Replace | |
| Door glass fails to operate up and down | Incorrect window glass installation | Adjust position |
| Damaged or faulty regulator arm or regulator | Correct or replace | |
| Door does not open or close completely | Incorrect door installation | Adjust position |
| Defective door check assembly | Correct or replace | |
| Door hinge requires grease | Apply grease | |
| Hood does not open or close completely | Striker and latch not properly aligned | Adjust |
| Incorrectly installed hood | Adjust | |
| Incorrect hood bumper height | Adjust | |
| Water leak through windshield end rear window | Defective seal | Fill with sealant |
| Defective flange | Correct |
Special Service Tools Tool (Number and name)IllustrationUse09861-31100Sealant cut-out toolCutting windshield sealant(use with 09861-31200)09861-31200Sealant cutting bladeCutting windshield sealant(use with 09861-31100)09861-31000Windshield moulding removerWindshield moulding removal09880-4F000Hog ring clip installerHog ring clip installation09816-2P100Power silent cutting toolTool box for removing panorama sunroof09816-2P110Air power toolAir tool for installing blade09816-2P121Cutter-1Blade for removing the front and side area of panorama sunroof (This blade has a inclination to push upward.
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the parking assist sensor. 4. Pull out the sensor (A) by opening the sensor holder (B) out.
Description BSD is a system that uses two magnetic wave radar sensors attached on the rear bumper to measure the distance from the following vehicles and provides the sensing and (visual and auditory) alarm of any vehicle coming into the blind spot.