Kia Cadenza YG: Body (Interior and Exterior) / Special Service Tools
| Special Service Tools |
| Tool (Number and name) | Illustration | Use |
| 09861-31100 Sealant cut-out tool |
| Cutting windshield sealant (use with 09861-31200) |
| 09861-31200 Sealant cutting blade |
| Cutting windshield sealant (use with 09861-31100) |
| 09861-31000 Windshield moulding remover |
| Windshield moulding removal |
| 09880-4F000 Hog ring clip installer |
| Hog ring clip installation |
| 09816-2P100 Power silent cutting tool |
| Tool box for removing panorama sunroof |
| 09816-2P110 Air power tool |
| Air tool for installing blade |
| 09816-2P121 Cutter-1 |
| Blade for removing the front and side area of panorama sunroof (This blade has a inclination to push upward.) |
| 09816-2P122 Cutter-2 |
| Blade for removing the front and side area of panorama sunroof (This blade has a inclination to push downward.) |
| 09816-2P123 Cutter-3 |
| Blade for removing the front and side area of panorama sunroof (This blade has a inclination to push downward.) |
| 09816-2P124 Cutter-4 |
| Blade for removing the front and side area of panorama sunroof (This blade has a inclination to push downward.) |
| 09816-2P127 Cutter-5 |
| Blade for removing the rear area of panorama sunroof |
| 09816-2P130 Cutter-10 |
| Blade for removing the edge area of panorama sunroof |
Specifications ItemsSpecificationHoodTypeRear hinged, gas lifter typeFront DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemRear DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemTrunk LidTypeTorsior bar typeSeat BeltsFront3 point type with Emergency Locking Retractor (E.
Troubleshooting SymptomSuspect AreaRemedy (Refer to page)Water leaks from panoramaroofDeteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance and improperly fitted weatherstripAdjustWind noise around panoramaroofLoose or deformed deflector, gaps in body workRetighten adjust or replaceNoise heard when opening.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures
Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Electrical System
- Automatic Transaxle System
- General Information
- New on site
- Most important about car
