Kia Cadenza YG: Exterior / Mirror Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body (Interior and Exterior) / Exterior / Mirror Repair procedures

Replacement
Outside Rear View Mirror Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the front door frame inner cover (A).

2.
Disconnect the outside rear view mirror connector (A).
3.
After loosening the mounting nuts, then remove the outside rear view mirror (B).
Tightening torque :
6.9~10.8 N.m(0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Installation is the reverse of removal.
Inside Rear View Mirror Assembly Replacement
Mirror Replacement
1.
Push the inside rear view mirror base (A) down to remove the inside rear view mirror assembly (B).

2.
Installation is the reverse of removal.
ECM Mirror Replacement
1.
Remove the ECM mirror cover (A).
2.
Disconnect the ECM mirror connector (B).

3.
Loosen the ECM mirror mounting screw (A).
4.
Push the ECM mirror base up to remove the ECM mirror assembly (B).

5.
Installation is the reverse of removal.
   
•
Make sure the connector is connected properly.

    Replacements Movable glass Replacement 1. Open the movable glass fully. 2. Remove the folding cover (A). 3. After loosening the mounting screws, then remove the movable glass (A).

    Replacement 1. Remove the cover (B) and remove the nuts, then remove the wiper arm (A). Tightening torque : 22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Description and Operation

    Description System Operation Typically, lane departure warning is activated at a speed over 70 KPH, but suppressed in case of unintentional lane departure when driver do not operate turn signal. System Operation Conditions 1. User Conditions (1) When unintended lane departure is occured, warnings are generated.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.     Make sure that there is no air leaking out of the blower and duct joints.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0426