Kia Cadenza YG: Exterior / Cowl Top Cover Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body (Interior and Exterior) / Exterior / Cowl Top Cover Repair procedures

Replacement
1.
Remove the cover (B) and remove the nuts, then remove the wiper arm (A).
Tightening torque :
22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 lb-ft)

2.
Detach the clips, then remove the cowl top cover (A).

3.
Installation is the reverse of removal.
   
•
Replace any damage clips.

    Replacement Outside Rear View Mirror Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures

    Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.     Make sure that there is no air leaking out of the blower and duct joints.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0207