Kia Cadenza YG: Body (Interior and Exterior) / Interior
- Console Components and Components Location
- Console Repair procedures
- Crash Pad Components and Components Location
- Crash Pad Repair procedures
- Roof Trim Components and Components Location
- Roof Trim Repair procedures
- Interior Trim Components and Components Location
- Interior Trim Repair procedures
- Trunk Trim Repair procedures
- Windshield Glass Components and Components Location
- Windshield Glass Repair procedures
- Rear Window Glass Repair procedures
Replacement 1. Remove the cover (B) and remove the nuts, then remove the wiper arm (A). Tightening torque : 22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.
Components 1. Gear knob & boots 2. Floor console upper cover3. Floor console upper cover tray4. Console side cover [LH]5. Console side cover [RH]6.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coolant from the radiator. 4. Remove the expansion valve cover (A).
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Control / Fuel System
- Mode Control Actuator Repair procedures
- Body (Interior and Exterior)
- New on site
- Most important about car
