Kia Cadenza YG: Bumper / Front Bumper Components and Components Location
Kia Cadenza YG 2016-2021 Service Manual / Body (Interior and Exterior) / Bumper / Front Bumper Components and Components Location
| Components(1) |
| 1. Front bumper cover 2. Front bumper upper weatherstrip 3. Radiator grill upper guide | 4. Front bumper side bracket [LH] 5. Front bumper side bracket [RH] |
| Components(2) |
| 1. Radiator grill 2. Front bumper license plate 3. Front bumper cover 4. Front bumper lip assmbly | 5. Front bumper center grill 6. Front bumper side grill 7. Fog lamp assembly 8. Front bumper energy absorber |
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Kia Cadenza YG 2016-2021 Service Manual: Heater & A/C Control Unit (DATC) Components and Components Location
C
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- High Pressure Fuel Pump Repair procedures
- Driveshaft and axle
- Mode Control Actuator Repair procedures
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0222