Kia Cadenza YG: Suspension System
- Specifications
- Special Service Tools
- Troubleshooting
- Front Suspension System
- Components and Components Location
- Front Strut Assembly Components and Components Location
- Front Strut Assembly Repair procedures
- Front Lower Arm Repair procedures
- Front Stabilizer Bar Repair procedures
- Front Cross Member Repair procedures
- Rear Suspension System
- Components and Components Location
- Rear Shock Absorber Components and Components Location
- Rear Shock Absorber Repair procedures
- Rear Upper Arm Repair procedures
- Rear Lower Arm Repair procedures
- Rear Stabilizer Bar Repair procedures
- Rear Assist Arm Repair procedures
- Trailing Arm Repair procedures
- Rear Cross Member Repair procedures
- Tires/Wheels
- Tire Pressure Monitoring System
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub.
Specifications Front Suspension ItemSpecificationSuspension typeMacPherson StrutShock absorberTypeHigh Performance Damper (H.P.D)Coil springFree Height [I.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment junction box cover. 3. Remove the driver side cover (A). 4. Remove the crash pad side switch assembly (A) by pushing it through side cover hole.
Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Components and Components Location
Component Location Components 1. Heater Case (LH)2. Separator3. Evaporator Core4. Shower Duct (LH)5. Heater Core Cover6. Heater Core7. Mode Actuator8. Mode Cam9. Temp Actuator (Drive)10. Vent Door Arm11. Floor Door Arm 1. Heater Case (RH)2.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Rail Pressure Sensor (RPS) Schematic Diagrams
- Components and Components Location
- Body (Interior and Exterior)
- New on site
- Most important about car
