Kia Cadenza YG: Tire Pressure Monitoring System / Components and Components Location
Kia Cadenza YG 2016-2021 Service Manual / Suspension System / Tire Pressure Monitoring System / Components and Components Location
| Components |
| 1. Receiver 2. TPMS sensor (FL) 3. TPMS sensor (RL) | 4. TPMS sensor (RR) 5. TPMS sensor (FR) |
Description Tread Lamp – Tire Under Inflation / Leak Warning. 1. Turn on condition • When tire pressure is below allowed threshold • When rapid leak is detected by the sensor.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.
Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Battery Troubleshooting
- Rail Pressure Sensor (RPS) Schematic Diagrams
- Timing Chain Repair procedures
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0291