Kia Cadenza YG: Suspension System / Rear Suspension System
- Components and Components Location
- Rear Shock Absorber Components and Components Location
- Rear Shock Absorber Repair procedures
- Rear Upper Arm Repair procedures
- Rear Lower Arm Repair procedures
- Rear Stabilizer Bar Repair procedures
- Rear Assist Arm Repair procedures
- Trailing Arm Repair procedures
- Rear Cross Member Repair procedures
Replacement 1. Remove the front wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when removing the front wheel & tire.
Components 1. Sub frame2. Coil spring3. Upper arm4. Assist arm5. Trailing arm6. Rear axle
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Pantoscopic Camera Repair procedures
Removal Front Pantoscopic Camera 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 3. Remove the pantocscpic camera (B) after loosening the mounting screws and connector (A).
Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body (Interior and Exterior)
- Suspension System
- Engine Electrical System
- New on site
- Most important about car
