Kia Cadenza YG: Tire Pressure Monitoring System / TPMS Receiver Repair procedures

Replacement
1.
Disconnect the negative (-) battery cable.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Disconnect the connector.
4.
Remove the bracket and receiver (A) as loosen the nut.

Tightening torque :
3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)

5.
Install in the reverse order of removal.
6.
Re-connect battery and turn Ignition on.
   
Firmly fasten the receiver connector until you hear a click.
Be careful not to damage any parts when moving or loading them.
7.
Replace the receiver, and then perform the learning process using a diagnostic instrument (GDS).
Vechicle Name Writing

VIN Writing

    Operation 1. General Function • Auto-locate/learn takes place only once per Ignition cycle. • On successful completion, 4 road wheel sensor ID''s, together with their respective road wheel positions are latched into memory for monitoring.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Power Mosfet Repair procedures

    Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. Specification FanMotor VoltageManualFirst speed3.8 ±0.5VSecond speed5.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures

    Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.028