Kia Cadenza YG: Back View Camera System / Repair procedures
| Removal |
| 1. |
Remove the trunk trim in the trunk after removing the screws and clips.
(Refer to Body - "Trunk") |
| 2. |
Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B).
|
| Installation |
| 1. |
Install the back view camera and camera holder. |
| 2. |
Install the trunk tirm. |
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Heater Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coolant from the radiator. 4. Remove the expansion valve cover (A).
Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures
Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Body (Interior and Exterior)
- General Information
- Timing Chain Repair procedures
- New on site
- Most important about car
