Kia Cadenza YG: Body Electrical System / Blind Spot Detection System
- Specifications
- Components and Components Location
- Description and Operation
- Repair procedures
- Blind Spot Detection Unit Schematic Diagrams
- Blind Spot Detection Unit Repair procedures
- Blind Spot Detection Variant Coding Description and Operation
- Blind Spot Detection Radar Calibration Description and Operation
- Blind Spot Detection Switch Components and Components Location
- Blind Spot Detection Switch Repair procedures
- Troubleshooting
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B).
Specifications ItemsSpecificationRated voltageDC 12VOperating voltage9V ~ 16VOperating speed15km/h ~ 250km/hSensible distance70m (Sedan)Curvature radiusStart : More than 100mStop : Less than 70mFrequency24 GHzNumbers2EA (Master 1EA, Slave 1EA)
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blower Motor Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. 3. If the problem is corrected, replace the blower motor.
Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures
Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- High Pressure Fuel Pump Repair procedures
- Mode Control Actuator Repair procedures
- Automatic Transaxle System
- New on site
- Most important about car
