Kia Cadenza YG: Back View Camera System / Description and Operation
Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Back View Camera System / Description and Operation
| Description |
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the
vehicle through the ECM (Reverse Display Room Mirror) mirror or AVN head
unit while backing-up.
This system is a supplementary function only. It is the
responsibility of the driver or always check the inside/ outside
rearview mirror and the area behind the vehicle before and while backing
up because there is a dead zone that can''t see through the camera. |
Circuit Diagram
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B).
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment junction box cover. 3. Remove the driver side cover (A). 4. Remove the crash pad side switch assembly (A) by pushing it through side cover hole.
Kia Cadenza YG 2016-2021 Service Manual: Compressor Components and Components Location
C
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Suspension System
- Body Electrical System
- Engine Control / Fuel System
- New on site
- Most important about car
Copyright © 2026 www.kcadenzavg.com - 0.0215