Other information:
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the negative ( ...
Removal and Installation
VIS 1 [Intake Manifold]
1.
Disconnect the battery "-" terminal.
2.
Remove the engine cover.
3.
Disconnect the VIS actuator hose (A).
4.
Remove the VIS actuator (B).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
5.
Insta ...