Kia Cadenza YG: Timing System / Front Oil Seal Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Engine Mechanical System / Timing System / Front Oil Seal Repair procedures

Replacement
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
2.
Remove the front oil seal (A).

3.
Using SST(09231-3C100), install a new front oil seal.

   
Do not reuse the front oil seal.
   
Insert the front oil seal into the timing chain cover as shown in illustration.

    Components 1. Front oil seal

    Components 1. Timing chain cover2. Gasket

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures

    Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.

    Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures

    Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.021