Kia Cadenza: Wipers and washers / Front windshield washers

Kia Cadenza YG 2016-2025 Owners Manual / Features of your vehicle / Wipers and washers / Front windshield washers

In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.

Use this function when the windshield is dirty.

The spray and wiper operation will continue until you release the lever.

If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.

The reservoir filler neck is located in the front of the engine compartment on the passenger side.

CAUTION - Washer pump

To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.

WARNING - Obscured visibility

Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on the windshield and obscure your vision.

CAUTION - Wipers & windshields

Windshield wipers
Operates as follows when the Engine Start/Stop button is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuous ...

Interior lights
Do not use the interior lights for extended periods when the engine is not running. It may cause battery discharge. WARNING - Interior Lights Do not use the interior lights when driving in ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Timing Chain Repair procedures


Removal 1. Set No.1 cylinder to TDC/compression. (1) Turn the crankshaft pulley clockwise and align its groove with the timing mark "T" of the lower timing chain cover. (2) Check that the mark of the camshaft timing sprockets are in straight line on the cylinder head surface as shown in ...

Kia Cadenza YG 2016-2025 Service Manual: Drive Belt Tensioner Repair procedures


Removal and Installation 1. Remove the drive belt idler. (Refer to Timing System - "Idler") 2. Remove the drive belt auto tensioner (A). Tightening torque Bolt (B) : 81.4 ~ 85.3N.m (8.3 ~ 8.7kgf.m, 60.0 ~ 62.9lb-ft) Bolt (C) : 17.7 ~ 21.6N.m (1.8 ~ 2.2kgf.m, 13.0 ~ 15.9lb-ft) 3 ...

Copyright © www.kcadenzavg.com 2017-2025