Kia Cadenza: Fuel Delivery System / Fuel Pump Control Module (FPCM) Specifications

Kia Cadenza YG 2016-2025 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump Control Module (FPCM) Specifications

Specification
Items
Specification
Applied Voltate (V)
6~18
Current Consumption (A)
Max. 15
Fuel Pressure 
Start
Max. 600 KPa (Max. 6.1 kgf/cm², Max. 87.0 psi)
In operation
350 ~ 500 KPa (3.5 ~ 5.1 kgf/cm², 50.7 ~ 72.5 psi)

Fuel Pump Control Module (FPCM) Description and Operation
Description The fuel pump control module (FPCM) is installed on the right side of the fuel tank and controls the DC motor mounted inside the low pressure fuel pump. The module compares instant ...

Fuel Pump Control Module (FPCM) Schematic Diagrams
Circuit Diagram Fuel Pressure Control Module (FPCM) Terminal And Input/Output signal FPCM Terminal Function Pin No.DescriptionConnected to1Fuel pressure sensor (FPS) power supply (+5V)Fuel Pres ...

Other information:

Kia Cadenza YG 2016-2025 Service Manual: Roof Antenna Repair procedures


Removal 1. Remove the rear roof trim. (Refer to Body - "Roof Trim") 2. Disconnect the connector (A) and cable (B) from the roof antenna. 3. Remove the roof antenna after removing a nut (A). Installation 1. Installation the roof antenna. 2. Connect the connector and cable. 3. ...

Kia Cadenza YG 2016-2025 Service Manual: Rear Combination Lamp Repair procedures


Rear Combination Lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (B) after removing the trim cover (A) in the trunk. 3. Remove the nuts (4EA). 4. Remove the r ...

Copyright © www.kcadenzavg.com 2017-2025