Kia Cadenza YG: Lighting System / Rear Combination Lamp Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Lighting System / Rear Combination Lamp Repair procedures

Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (B) after removing the trim cover (A) in the trunk.

3.
Remove the nuts (4EA).

4.
Remove the rear combination lamp (A) after disconnecting the connector (B).

5.
Turn the socket counterclockwise to remove the turn signal lamp bulb (A).

Rear Combination Lamp (Inside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp assembly, replace the back up lamp bulb (A) after removing the trim cover in the trunk.

3.
Remove the rear combination lamp (A) after removing the connector and nuts (3EA).

4.
Turn the socket counterclockwise to remove the back up lamp bulb (A).

Installation
1.
Install the rear combination lamp assembly after assembling the bulb.
2.
Install the lamp cover to the tailgate after connecting the lamp connector.

    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to Body - "Roof Trim") 3. Disconnect the connector of high mounted stop lamp.

    Removal Mood Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door") 3. Remove the connector and LED mood lamp (A).

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Surround View Monitoring Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") 3. Remove the SVM unit (B) after disconnecting the connectors (A) and mounting bolts. Installation 1. Install the SVM unit.

    Kia Cadenza YG 2016-2021 Service Manual: Blower Resistor Repair procedures

    Inspection 1. Measure terminal - to - terminal resistance of blower resistor. 2. If measure resistance isnot within specification, the blower resistor must be replaced. Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower cover (A) and then disconnect the connector (B).

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0237