Kia Cadenza YG: Lighting System / High Mounted stop lamp Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Lighting System / High Mounted stop lamp Repair procedures

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim")
3.
Disconnect the connector of high mounted stop lamp.

4.
Remove the high mounted stop lamp (B) after removing the bolts (2EA).

Installation
1.
Install the high mounted stop lamp to the roof trim.
2.
Install the roof trim.

    Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the lighting switch of the multi-function switch. (Refer to the multi-function switch) 3.

    Rear Combination Lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (B) after removing the trim cover (A) in the trunk.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Photo Sensor Description and Operation

    Description 1. The photo sensor is located at the center of defrost nozzle. 2. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received which is transferred to the automatic tem

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.     Make sure that there is no air leaking out of the blower and duct joints.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0295