Kia Cadenza YG: Airbag Module / Curtain Airbag (CAB) Module Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Description and Operation

Description
Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by using side impact sensor (SIS) signal.
   
Never attempt to measure the circuit resistance of the airbag module even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.

    Removal Front Side Airbag 1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the front seat assembly.

    Components

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Immobilizer Control Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening the bolt. Installation 1.

    Kia Cadenza YG 2016-2021 Service Manual: Mode Control Actuator Repair procedures

    Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the terminal 3and grounding terminal 7. 4. Verify that the mode control actuator operates to the vent mode when connecting in the reverse.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0257