Kia Cadenza YG: Airbag Module / Passenger Airbag (PAB) Module Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Description and Operation

Description
Passenger Airbag (PAB) module is located in the passenger crash pad. This PAB contains 2 firing squibs of airbag and 1 firing squib of active vent. Depending of crash speed or the tightening of seat belt, it is decided a timing about both 2 firing squibs of airbag and 1 firing squib of active vent. At the moment of vehicles collisions, the firing squib of active vent make airbag distended and then consecutively leaked gases of airbag through a hole at once. These operations reduce an injury of the passenger''s head. At first, the active vent sets a rapid deployment of airbag by keeping the pressure, after deployment of airbag it emits the gases of upper airbag. The Working Principle of Tether Cutter: When receive an electrical signal, Tether Cutter cuts a strap which is been attached Active vent in order to open a hole of upper airbag.
The working range of Active Vent
1)
If occupant in passenger seat is not belted, active vent is disposed in the end of crash event regardless of crash severity.
2)
If occupant is belted and crash severe enough to require 2 stage passenger airbag deployment is occurred, active vent is activated to optimize occupant protection.
3)
Low-Speed + Belted : Inflator of Primary Fire + 2 Stage & Active Vent disposal in the end of crash event.
   
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will result in serious personal injury.

    Removal 1. Set the front tires straight-ahead before removing the steering wheel.     If the steering wheel and the front tires are not set straight ahead together, it affects the number of circulation of steering wheel and the cable inside the clock spring is possible to be damaged.

    Components

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Parking Assist Sensor Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the parking assist sensor. 4. Pull out the sensor (A) by opening the sensor holder (B) out.

    Kia Cadenza YG 2016-2021 Service Manual: Ambient Sensor Description and Operation

    Description 1. The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor resistance will increase with lower temperature, and decrease with higher temperatures.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0227