Kia Cadenza YG: SRSCM / Seat Belt Buckle Switch (BS) Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to Body - "Front seat")
3.
Disconnect the connector mounting clip (A).

4.
Loosen the seat belt buckle mounting bolt and remove the seat belt buckle switch (A).

Installation
   
Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)
4.
Install the front seat assembly.
(Refer to Body - "Front seat")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
•
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.

    Components

    Description In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passenger side Body Detection System. If the seat is occupied, Body sensor detects how measuring electrostatic capacity and send signal to SRSCM via CAN.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Description and Operation

    System Overview RPAS (Rear Parking Assist System) is an electronic driving aid that warns the driver to be cautious while parking or in low speed environments. The sensor uses ultrasonic waves to detect objects within proximity of the vehicle.

    Kia Cadenza YG 2016-2021 Service Manual: Components and Components Location

    C

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0328