Kia Cadenza YG: Engine Control / Fuel System / Special Service Tools

Special Service Tools
Item
Illustration
Application
Fuel Pressure Gauge
(09353-24100)

Measuring the fuel line pressure
Fuel Pressure Gauge Adapter
(09353-02100)

Connection between the high pressure fuel pump and the fuel feed line
Heated Oxygen Sensor Socket Wrench
(09392-1Y100)

Removal and installation of the heated oxygen sensor

※ SST No.09392-2H100 model also can be used for removing the Heated Oxygen Sensor.
Torque Wrench Socket (17mm)
(09314-3V100)

Removal and installation of the high pressure fuel pipe
Injector Combustion Seal Guide & Sizing tool
(09353-2B000)

Installation of the injector combustion seal

    Specifications Fuel Delivery System ItemsSpecificationFuel TankCapacity70 lit. (18.5 U.S.gal., 74.0 U.S.qt., 61.6 Imp.qt.)Fuel FilterTypePaper typeFuel PressureLow Pressure Fuel Line343 ~ 500 kPa (3.

    Basic Troubleshooting Basic Troubleshooting Guide Customer Problem Analysis Sheet Basic Inspection Procedure Measuring Condition of Electronic Parts'' Resistance The measured resistance at high temperature after vehicle running may be high or low.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws.     Take care not to separate the bracket from rear bumper when removing the BSD sensor.

    Kia Cadenza YG 2016-2021 Service Manual: Cluster ionizer Repair procedures

    Inspection 1. Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch. DisplayFail description00Normal50Cluster ionizer fault * Diagnostic procedure refer to DTC code. Replacement 1. Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0412