Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute
pressure of the surge tank and transfers the analog signal proportional
to the pressure to the ECM.
By using this signal, the ECM calculates the intake air quantity and engine speed.
The MAPS consists of a piezo-electric element and a hybrid IC
amplifying the element output signal. The element is silicon diaphragm
type and adapts pressure sensitive variable resistor effect of
semi-conductor.
Because 100% vacuum and the manifold pressure apply to both
sides of the sensor respectively, this sensor can output analog signal
by using the silicon variation proportional to pressure change.
Removal
Height Sensor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the height sensor linkage (A) installed on the front axle and rear axle.
[Front]
[Rear]
Installation
Height Sensor
1.
Install the height sensor assembly after connecting the connector.
Removal
Front Pantoscopic Camera
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Remove the pantocscpic camera (B) after loosening the mounting screws and connector (A).