Kia Cadenza YG: Automatic Transaxle Control System / Output Speed Sensor Specifications
| Specifications |
| Operation condition [°C(°F)] | ((-)40~150)) -40~302 | |
| Air gap(mm)in. | (0.8~1.25) 0.032~0.049 | |
| Output voltage | High | 1.18~1.68 |
| Low | 0.59~0.84 | |
Description The output speed sensor is a vital unit that measures the rate of rotation of the transaxle''s turbine shaft and output shaft, and delivers the readings to the Transaxle Control Module(TCM).
Circuit Diagram
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting screws. Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Kia Cadenza YG 2016-2021 Service Manual: Blind Spot Detection Radar Calibration Description and Operation
Description To sense the cars exactly in the next lane with the radar, the direction of the sensor and the direction of the vehicle have to align. This is BSD unit alignment. If this alignment is not performed as below illustration, the degradation of detection performance and the cause of false alarms.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Electrical System
- Timing Chain Repair procedures
- Engine Control / Fuel System
- New on site
- Most important about car
