Kia Cadenza YG: Automatic Transaxle Control System / Output Speed Sensor Description and Operation

Kia Cadenza YG 2016-2021 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor Description and Operation

Description
The output speed sensor is a vital unit that measures the rate of rotation of the transaxle''s turbine shaft and output shaft, and delivers the readings to the Transaxle Control Module(TCM). The sensor provides critical input data that''s used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.

    Inspection 1. Turn ignition switch OFF. 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") 3. Disconnect the solenoid valve connector (A).

    Specifications ▷ Type: Hall effect sensor Operation condition [°C(°F)]((-)40~150)) -40~302Air gap(mm)in.(0.8~1.25) 0.032~0.049Output voltageHigh1.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.

    Kia Cadenza YG 2016-2021 Service Manual: Ambient Sensor Description and Operation

    Description 1. The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor resistance will increase with lower temperature, and decrease with higher temperatures.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.021