Kia Cadenza YG: Surround View Monitoring (SVM) System / Surround View Monitoring Switch Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Surround View Monitoring (SVM) System / Surround View Monitoring Switch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
3.
Disconnect the console upper cover connector (A).

4.
Remove the cup holder assembly (A) after loosening the mounting screws.

5.
Remove the SVM switch (A) after loosening the mounting screws.

Installation
1.
Install the SVM switch and cup holder assembly.
2.
Install the console upper cover.

    Removal Front Pantoscopic Camera 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 3.

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.     Make sure that there is no air leaking out of the blower and duct joints.

    Kia Cadenza YG 2016-2021 Service Manual: Heater & A/C Control Unit (DATC) Repair procedures

    Inspection Self diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code. After the display panel flickers three times every 0.5 second, the corresponding fault code flickers on the setup temperature display panel every 0.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0329