Kia Cadenza YG: Body Electrical System / Surround View Monitoring (SVM) System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Repair procedures
- Surround View Monitoring Unit Components and Components Location
- Surround View Monitoring Unit Repair procedures
- Pantoscopic Camera Components and Components Location
- Pantoscopic Camera Repair procedures
- Surround View Monitoring Switch Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle.
Components Component Functions No.ComponentsQuantityMajor Role1SVM Unit1 – Input video information from 4 channel cameras and process display – Vehicle communication (CAN) and system control – Screen output in 8 view modes 2Ultra optical camera(190 degrees)4 – Record vehicle''s surrounding area 3AVN Head Unit1 – Provide driver with video via SVM ECM output – Send user input data to SVM ECM 4SVM Switch1 – Input video feed in Front Mode
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with an PCM(ECM) request for vehicle specific data (PIN code: 6digits) from the tester.
Kia Cadenza YG 2016-2021 Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. 3. Recover the refrigerant with a recovery/charging station.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- General Information
- Timing Chain Repair procedures
- Restraint
- New on site
- Most important about car
