| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the passenger compartment juction box cover. |
| 3. |
Remove the crash pad side switch assembly (A) by pushing it through juction box cover hole.
|
| 4. |
Remove the rear curtain switch (A) after disconnecting the connectors.
|
| Installation |
| 1. |
Install the rear curtain switch and connector to the crash pad. |
| 2. |
Install the passenger compartment juction box cover. |
| Inspection |
| 1. |
Operate the switch and check for continuity between terminals with an ohmmeter.
|
Inspection 1. AUTO UP/AUTO DOWN function (1) IGN ON, if you press the rear curtain switch, rear curtain motor operates the reverse direction of the before direction.
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.
Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.