| Adjustment |
| Transaxle Control Module(TCM) Learning |
| • |
Transaxle assembly replacement |
| • |
TCM replacement |
| • |
TCM upgrading
|
| TCM learning procedure |
| 1. |
ATF temperature: 40~100°C (104~212°F) |
| 2. |
Static learning
Repeat the below shift pattern four times or more with stepping on the brake.
|
| 3. |
Driving learning
Drive the vehicle from a stop in D through all gears 1st,
2nd, 3rd, 4th, 5th and 6th gear while holding the throttle steady at the
specified TPS value (15~25%). |
Description Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values.
Circuit Diagram
Component Location Components 1. Heater Case (LH)2. Separator3. Evaporator Core4. Shower Duct (LH)5. Heater Core Cover6. Heater Core7. Mode Actuator8. Mode Cam9. Temp Actuator (Drive)10. Vent Door Arm11. Floor Door Arm 1. Heater Case (RH)2.
Inspection 1. Ignition "OFF" 2. Disconnect the connector of temperature control actuator. 3. Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 7. Verify that the temperature control actuator operates to the cool position when connecting in the rev