Other information:
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery negative (-) cable after removing the bolt (B).
Installation
1.
Install in the reverse order of removal.
Battery (-) termi ...
Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :
9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft)
2.
Remove the desiccant (A) from condenser using a long nose plier. Check for crumbled desiccant and clogged b ...