Kia Cadenza YG: Lighting System / Rheostat Repair procedures
| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the passenger compartment juction box cover. |
| 3. |
Remove the side cover (A).
|
| 4. |
Remove the crash pad side switch assembly (A) by pushing it through side cover hole.
|
| 5. |
Disconnect the rheostat connector (A) from lower crash pad switch.
|
| 6. |
Operate the rheostat switch and check for continuity between terminals.
|
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the center fascia panel (A) with hazard lamp switch. Apply the protective tapes to the center fascia panel and its related parts.
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the lighting switch of the multi-function switch. (Refer to the multi-function switch) 3.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Height Sensor Repair procedures
Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. [Front] [Rear] Installation Height Sensor 1. Install the height sensor assembly after connecting the connector.
Kia Cadenza YG 2016-2021 Service Manual: Lane Departure Warning System (LDWS) Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Remove the LDWS unit connector (A). 4. Remove the LDWS unit after widening the mounting clips. Installation 1. Install the LDWS unit. 2.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- General Information
- Schematic Diagrams
- Body (Interior and Exterior)
- New on site
- Most important about car
