| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the center fascia panel (A) with hazard lamp switch.
|
| 3. |
Disconnect the in-car hose (A) and hazard lamp switch connector (B).
|
| 4. |
Remove the hazard lamp switch assembly (A) after removing the screws.
|
| Installation |
| 1. |
Install the hazard lamp switch. |
| 2. |
Install the center fascia panel. |
Removal 1. Disconnect the negative(-) battery terminal. 2. Disconnect the connector (B) after removing the license lamp assembly (A). 3. Turn the license bulb socket (A) counterclockwise to remove the bulb.
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the passenger compartment juction box cover. 3. Remove the side cover (A).
Inspection 1. Ignition "OFF" 2. Disconnect ambient temperature sensor. 3. Check the resistance of ambient temperature sensor between terminals 1 and 2 whether it is changed by changing of the ambient temperature. 1. Sensor Ground2.
Component Location Components 1. Heater Case (LH)2. Separator3. Evaporator Core4. Shower Duct (LH)5. Heater Core Cover6. Heater Core7. Mode Actuator8. Mode Cam9. Temp Actuator (Drive)10. Vent Door Arm11. Floor Door Arm 1. Heater Case (RH)2.