Kia Cadenza YG: Air Conditioning System / Photo Sensor Description and Operation
| Description |
| 1. |
The photo sensor is located at the center of defrost nozzle. |
| 2. |
The photo sensor contains a photovoltaic (sensitive to
sunlight) diode. The solar radiation received by its light receiving
portion, generates an electromotive force in proportion to the amount of
radiation received which is transferred to the automatic temperature
control module so that the solar radiation compensation will be
performed. |
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor.
Inspection 1. Ignition "ON" 2. Using the scan tool. 3. Emit intensive light toward photo sensor using a lamp, and check the output voltage change.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Start/Stop Button Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screw driver or remover, remove the center fascia lower panel (A). 3. Remove the in-car hose (A) and disconnect the connectors (B) from the heater & A/C control unit. 4.
Kia Cadenza YG 2016-2021 Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft) 2. Remove the desiccant (A) from condenser using a long nose plier.
Categories
- Manuals Home
- Kia Picanto Owners Manual
- Kia Picanto Service Manual
- Front Bumper Repair procedures
- Body (Interior and Exterior)
- Driveshaft and axle
- New on site
- Most important about car
