Kia Cadenza YG: Lighting System / License Lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Disconnect the connector (B) after removing the license lamp assembly (A).
|
| 3. |
Turn the license bulb socket (A) counterclockwise to remove the bulb.
|
| Installation |
| 1. |
Install the bulb. |
| 2. |
Install the license lamp assembly. |
Inspection Overhead Console Lamp Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the center fascia panel (A) with hazard lamp switch. Apply the protective tapes to the center fascia panel and its related parts.
Other information:
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Components and Components Location
Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Blower Upper Case10. Blower Lower Case11. FET12. Resistor13.
Kia Cadenza YG 2016-2021 Service Manual: Blower Unit Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower unit.(Refer to HA group – heater unit). 3. Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws. Make sure that there is no air leaking out of the blower and duct joints.
Categories
- Manuals Home
- Kia Cadenza Owners Manual
- Kia Cadenza Service Manual
- Engine Electrical System
- Emission Control System
- Body Electrical System
- New on site
- Most important about car
