Kia Cadenza YG: Seat Electrical / Seat Heater Repair procedures

Kia Cadenza YG 2016-2021 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Repair procedures

Inspection
First Seat Heater
1.
Check for continuity and measure the resistance between No.1 and NO.4 terminals.

No.
Description
No.
Description
1
Heater (-)
3
NTC (+)
2
NTC (-)
4
Heater (+)

Standard value (Fabric / Leather)
Cushion : 1.04 Ω ± 10%
Back : 1.1 Ω ± 10%
Set : 2.14 Ω ± 10%
2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value (Fabric / Leather)
Cushion :
1 Step : 40 ± 2°C(104 ± 3.6°F)
2 Step : 42 ± 2°C(107.6 ± 3.6°F)
Back :
1 Step : 46 ± 2°C(114.8 ± 3.6°F)
2 Step : 52 ± 2°C(125.6 ± 3.6°F)
3.
Check for continuity between the terminals after disconnecting the connector.
2nd Seat Heater
1.
Check for continuity and measure the resistance between No.1 and NO.4 terminals.

No.
Description
No.
Description
1
Heater (-)
3
NTC (+)
2
NTC (-)
4
Heater (+)

Standard value (Fabric / Leather)
Cushion : 1.16 Ω ± 10%
Back : 1.16 Ω ± 10%
Set : 2.32 Ω ± 10%
2.
Operate the seat warmer after connecting the 3P connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value (Fabric / Leather)
Cushion :
1 Step : 40 ± 2°C(104 ± 3.6°F)
2 Step : 42 ± 2°C(107.6 ± 3.6°F)
Back :
1 Step : 46 ± 2°C(114.8 ± 3.6°F)
2 Step : 52 ± 2°C(125.6 ± 3.6°F)

    Circuit Diagram

    Circuit Diagram

    Other information:

    Kia Cadenza YG 2016-2021 Service Manual: Repair procedures

    Removal 1. Remove the trunk trim in the trunk after removing the screws and clips. (Refer to Body - "Trunk") 2. Remove the camera holder (A) as shown arrow direction, and then remove the back view camera (B). Installation 1. Install the back view camera and camera holder.

    Kia Cadenza YG 2016-2021 Service Manual: Condenser Repair procedures

    Inspection 1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdriver or pliers. 2. Check the condenser connections for leakage, and repair or replace it, if required.

    Categories

     
    Copyright © 2026 www.kcadenzavg.com - 0.0286